![]() Is there something I have to do to prepare this brush or am I better off buying something already prepared? (If I should get something that is already formed, please give me a link. The videos I've seen with my type of pattern have a much more flattened brush. The HomeDepot person told me this is what I needed for my ceiling pattern. I purchased this brush (see below) years and years ago on the off chance I would need it to do patching.Would I be better off using the self-adhesive drywall tape or the paper drywall tape for this type of repair?.On the crack between the nail-pop and the patch, should I prepare that somehow or will it be fine when I apply compound over it with the paint roller? My fear is that the crack will cause a crack in the final work over time. Practice on a sheet of drywall, 2 by 2 from the home improvement store laying on your floor to achieve desired affect.As I tape between the existing ceiling with pattern and the patch, should I prepare the patterned side somehow? I was contemplating sanding an inch gap around the patch to give the tape a place to sit, but I'm not sure of the best way.An alternate method is to dip the slap brush into the drywall mud and stamp it on the wall. ![]() Then apply joint compound to the wall and stamp it with your slap brush. Mix the joint compound with water to thin it out. Select a natural-bristle brush to achieve the best coverage for stains and oil-based paint. Synthetic brushes made of polyester, nylon or a combination of both work particularly well with water-based paint. For either method, you’ll need joint compound, water, and a slap brush. Choose from a range of brush head sizes from less than an inch for detailing and small crafts to over 4 inches for wide surfaces. So, the gap is about half as much, maybe a bit over an 1/8". There are two methods to achieve a slap brush wall texture.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |